SimuDrape Webinar (German): July 30, 2020

23. July 2020

The forming of 2D pre-products into complexly shaped 3D parts is one of the most determining processing steps in manufacturing of continuously fiber-reinforced polymers. But how can you use your existing ABAQUS software architecture to virtually ensure the formability of continuously fiber-reinforced polymers?

In a webinar hosted by “Allianz Faserbasierte Werkstoffe Baden-Württemberg e.V.” and SIMUTENCE within the Virtual Composites Show, our co-founder Dr. Dominik Dörr will take you on a journey through process simulation of continuously fiber-reinforced polymers (CoFRP).

We will address how the simulation can improve product development cycles and how process simulation can be used to prevent the cost-expensive trial and error design of manufacturing processes. These insights will be complemented by an introduction of SimuDrape, our add-on for ABAQUS for the advanced forming simulation of CoFRP. This makes ABAQUS ready to be used for high fidelity forming simulation of CoFRP.

 

Webinar highlights:

  • Introduction into the manufacturing and the virtual design of CoFRP
  • Limitations of ABAQUS built-in techniques for CoFRP forming simulation
  • Introduction to SimuDrape
  • Presentation of application examples

 

Registration:

The webinar takes place on July 30, 2020, from 11:00 to 12:00 (CEST). Use the link below for the free registration. Please note, this webinar will be held in German. We will follow up with an English webinar later this year.